Cleaning - Meridian D6000 User Manual

Help 46
FCC WARNING: This equipment generates and can radiate radio fre-
quency energy, and if not installed and used correctly in accordance with
our instructions may interfere with radio communications or radio and
television reception. It has been type-tested, and complies with the limits
set out in Subpart J, Part 15 of FCC rules for a Class B computing device.
These limits are intended to provide reasonable protection against such
interference in home installations.
If this equipment does interfere with or suffer interference from radio or
television reception, then the following measures should be tried:
1. Reorient the receiving aerial (or antenna), or route the antenna cable
of the receiver as far away as possible from the D6000 and its cabling
2. Ensure that the receiver uses well-screened antenna cable
3. Relocate the receiver with respect to the D6000
4. Connect the receiver and this product to different AC outlets
5. If the problem persists, contact your dealer
EEC This product has been designed to comply with the limits set out in
EN55013 and EN55020C.
REMEMBER to switch all units off before changing any connections.

Cleaning

The D6000 is in two major parts, the head and base, these should be
cleaned separately. Disconnect the power cord before doing this.
The front of the D6000 is glass set in a metallic frame. To clean the metal
do not use abrasive cleaners or solvents. A barely damp chamois leather
is recommended.
The grilles should not be cleaned. If they becomes dusty a very gentle
vacuum cleaning may be possible. To remove grilles hold them in the
centre of each side and gently pull away from the cabinet. It may help to
ease it off the restraints.
The digital audio sockets are gold plated, and where gold-plated phono
plugs are used there should be no need for cleaning of the contacts. For
non-gold-plated phono plugs, it is good practice to unplug and re-plug the
plugs at least once a year. Some proprietary contact cleaners may be
used to some advantage, but you should seek your dealer's advice.
One or two days after installation check the tightness of the screws
retaining the drivers. These screws may loosen in shipping or with
extremes of temperature or humidity, and the speaker will not sound at its
best if these are loose. These screws should be checked every few
months particularly if the speakers are played loud for extended periods of
time.
No routine maintenance of the electronics is required. There are no user-
serviceable parts inside the D6000.
The display panel is glass, and should be cleaned using a barely damp
chamois leather.
Do not use abrasive cleaners on any part of the D6000.
D6000 User Guide