Table of Contents
Advertisement
responses of the tilt control in D6000 are shown in Appendix 4 on page
54.
To review the tilt setting:
1. Press the w or the e menu key until the tilt display shows. The
master display will momentarily show
t.
0.0
This allows you to ask the D6000 what its tilt setting is without changing it.
Note We call this kind of display a cursor – in this case, the tilt cursor.
D6000 uses several cursors to access functions such as tilt, bass, track
selection and preset selection.
To get rid of a cursor, either
wait a few seconds, or
select another cursor, or
hit another (inactive) key
To change the tilt setting:
1. Make sure that you can see the tilt cursor display on the master:
t.
0.0
2. Press the n menu key. The display will change to
t.
0.5
and the sound will get a little brighter.
3. Press n again. The display will move to
t.
1.0
To dim the sound:
1. Use the menu s key instead
The tilt can be adjusted between ±10 dBs, incremented in 0.5 dB steps.
To restore the flat condition, press Clear.
Note This also restores loudness, balance and bass.
To store a tilt setting, you must be in Setup mode; see page 35.
To recall a tilt setting, use the Store key; see page 22.
Tilt explained
The tilt control allows you to adjust the broad balance of the D6000 to
correct for the acoustics of your listening room, or for a misbalanced
recording.
Normally, settings between 1.0 and –2.0 will give the most natural result.
All D6000s in the installation take on the same tilt setting as the master.
This is essential for correct stereo.
Bass control
The bass control allows you to adjust the bass response in the room. The
responses of the bass control in D6000 are shown in Appendix 4 on page
54.
To adjust the bass:
1. Press the w or e menu key until the bass cursor display shows. The
master display will momentarily show
Using D6000
19
D6000 User Guide
Advertisement
Table of Contents
