Meridian D6000 User Manual page 53

Controls
Test mode
Remote key Logo
CD 1L
Radio 1r
LP 2L
TV 2r
3L
Tape 1
Tape 2 3r
CDR 4L
Cable 4r
Internally generated test signals
A number of internally generated test signals are available in Calibrate
mode. These include:
one sample width impulse with 2Hz repetition rate
four sample width impulse with 2Hz repetition rate
pink noise
To switch from the input to the test signals:
1. Press the w or e menu key until you see a display like this:
OFF
indicating that signal generation is off.
2. Press the n or s menu key to move between a narrow impulse, a
wide impulse and pink noise, with these displays:
thin
FAt
To set the relative level of the tweeter:
1. Press the w or e menu key until you see a display like this:
t 0.0
indicating a relative tweeter setting of 0.0dB
2. Press the n or s menu key to move in 0.5dB steps over the range
±1.5dB
To set the relative level of the bass:
1. Press the w or e menu key until you see a display like this:
b 0.0
indicating a relative bass setting of 0.0dB
2. Press the n or s menu key to move in 0.5dB steps over the range
±1.5dB
Getting out of Calibrate
Once calibration is compete:
1. switch the D6000 off and then on again while pressing Clear.
Input on Control?
D6000
D1 No
D1 No
D2 No
D2 No
O1 No
O1 No
O2 No
O2 No
Appendix 53
Channel
selected
Left
Right
Left
Right
Left
Right
Left
Right
D6000 User Guide