Table of Contents
Advertisement
Use with 504, 204 or 604 FM tuner
C.
6
Press Play to action a programmed sequence.
When a 204 or 604 is the system tuner, it can be controlled by the MSR
but only if the D6000s are set up in 200 mode (for example by selecting
Type 2. A 504 tuner can operate in both 200 and 500 modes.
Select the tuner with Radio. The display will show
rd.
##
where ## is the volume number. (If you are using another tuner which the
D6000 cannot control, see the setup section on page 34, select comms to
'N.C.')
To select a preset station, e.g. preset 4
1. Press 4
The D6000 will show a 'select cursor' display. For 500 mode the display
is:
P.
4
For 200 mode the display is:
S.
4
2. Either press Play or wait for a short time. The tuner will go to preset
number 4.
To select a higher preset, e.g. 23
1. Press 2 followed by 3
The D6000 will display
P.
23
and then the tuner will go to preset 23.
The master D6000 can display either the preset number of the tuned
station or its frequency. For example, if we tune to 92.3MHz and store this
frequency as preset number 3, we can then press Display repeatedly and
watch the master rotate its display between the following:
rd
##
P.
3
92.3
Note The D6000 cannot show the time displays of the 204.
6. Use the system, or put it into Standby.
Operation
25
D6000 User Guide
Advertisement
Table of Contents
