Connecting D6000 - Meridian D6000 User Manual

Connecting D6000

1. Switch off the master D6000, using the power switch on the back, and
wait for 3 seconds
2. While pressing the Store key on the remote control, switch the power
on again. The display will momentarily show
SEt
3. Release the Store key
The master will revert to the Standby display and condition. You may now
use the speakers normally.
When customisation is complete and you are sure that you have stored
the correct tone settings independently for every source you wish to
change:
1. Switch the power off and then on again to restore Normal operation
In Normal operation, the settings you have made will be retained and
cannot be changed without going back to Setup.
Storing settings
To store the current settings, get into a bass, tilt, axis or phase cursor by
1. Pressing the w or e menu key until a cursor display appears
2. While this display is up, pressing Store
Sto.
The D6000 will respond with the store message
Recalling settings in Setup
The Store key operates normally as a recall when there is no tone cursor
displayed.
1. Wait for a volume, track or time display on the master
2. Press Store
Limitations of storing
Tilt and bass settings are stored by each source independently. Phase,
axis and boundary settings are stored for all sources, and the last setting
stored is that used for all sources.
Note When customisation is complete, switch the power off, wait for 3
seconds, then switch it on again to restore normal operation and to save
what you have done.
Four types of connection must be made to the D6000:
power (see page 12)
digital audio (see page 38)
communications (see page 39)
You will need to plan the connections with the installation you wish to
achieve in mind. It is best to do this while deciding where to put the
D6000s, as this decision may affect the positioning of the rest of your
system, and the way in which you connect it. The decision as to which
speaker should be master is also dependent on both positioning and
connections.
The following sections will explain in detail the options open to you.
Remember that your Meridian dealer is chosen for his expertise in this
area. If in doubt, you can always refer to him.
Customising using Setup
D6000 User Guide
36