Appendix 3 Calibrate Mode - Meridian D6000 User Manual

Appendix 3 Calibrate mode

Controls
Test mode
Remote key Logo
CD 1L
Radio 1r
LP 2L
TV 2r
3L
Tape 1
Tape 2 3r
CDR 4L
Cable 4r
WARNING: THIS MODE MAY CHANGE THE RESPONSE OF YOUR
SPEAKER, AND SHOULD ONLY BE USED BY A QUALIFIED SERVICE
ENGINEER.
The process of calibration is carried out during production; it alters the
level of tweeter and bass to compensate for the variability found in drive
units. It should therefore only be used if a drive unit needs to be replaced.
To enter Calibrate mode:
1. Adjust the MSR to emulate a 609 handset. (See MSR documentation
for changing internal jumpers).
2. Switch on the power supply to the speaker while pressing the Repeat
key on the MSR
The calibration display looks like the Test mode display (see Appendix 2):
1L 65
This shows that you are in Calibrate mode and that the volume level is 65.
This mode operates like Test, but three menus are enabled.
Input on Control?
D6000
D1 No
D1 No
D2 No
D2 No
O1 No
O1 No
O2 No
O2 No
Appendix 52
Channel
selected
Left
Right
Left
Right
Left
Right
Left
Right
D6000 User Guide