Adding Items During A Cycle - Kenmore 665.15982 User Manual

You can add an item anytime before the main wash starts.
Open the door and check the detergent dispenser. If the
main wash section is still closed, you can add items.
To add items
1. Lift up the door latch to stop the cycle. Wait for the
spraying action to stop before opening the door.
2. Open the door. If the main wash detergent dispenser is
still closed, add the item.
3. Close the door firmly until it latches. The dishwasher
resumes the cycle after about a 5 second pause.
You can customize your cycles by pressing an option. If
you change your mind, press the option again to turn the
option off. Select a different option if desired.
You can change an option anytime before the selected
option begins. For example, you can press an unheated
drying option any time before drying begins.
Press START to use the same cycle and option(s) as the
previous wash cycle.
NOTE: If the last cycle you completed was a rinse cycle,
when you press Start, the dishwasher runs the last full
wash cycle and options.
Water Heat
Select this option to heat the water to 140°F (60°C) during
parts of the cycle. (See the Cycle Chart.) Heating the water
helps improve washing results. This option adds both heat
and wash time to parts of the cycle.
NOTE: Pots Pans automatically uses this option. Water
Heat is an option with the Normal Wash and Water Miser
cycles.
Sani Rinse
Select this option to raise the water temperature in the final
rinse to approximately 155 ° F (68 ° C) for 10 minutes. Sani
Rinse adds heat and time to the cycle. In the Normal cycle
this high-temperature rinse sanitizes your dishes and
glassware in accordance with the NSF International
requirements (#95/480/05/2480).
NOTE: Sani Rinse is an option with Pots Pans, Normal
Wash and Water Miser.
No Heat Dry
Select this energy-saving option to dry without heat. No
Heat drying is useful when loads contain plastic
dinnerware that may be sensitive to high temperatures.
The dishes take longer to dry and some spotting can
occur. For best drying, use a liquid rinse aid. Some items
(such as plastics) may need towel drying.
NOTE: Quick Wash and Quick Rinse automatically use this
option. No Heat Dry is an option with all other cycles.
Control Lock On
Use the Lock to prevent your dishwasher from accidentally
being turned on. Use the Lock, also, to prevent accidental
cycle or option changes during a cycle.
GD
LOCKON
When LOCK ON is lit, all buttons are disabled.
NOTES:
• The dishwasher door can be opened while the controls
are locked.
• You can turn on the Lock while the dishwasher is
running.
To turn on the Lock
Press and hold
for 4 seconds. LOCK ON glows.
If you press any pad while your dishwasher is locked, the
light flashes 3 times.
TO turn off the Lock
Press and hold NO HEAT DRY for 4 seconds. The light
turns off.
17