Adding Items During A Cycle; Option Selections - Kenmore ULTRA WASH 665.15762 Use & Care Manual

Adding Items During a Cycle
You can add an item anytime before the main wash starts. Open
the door and check the detergent dispenser. If the main wash
section is still closed, you can add items.
To add items
1. Lift up the doer latch to stop the cycle. Wait for the spraying
action to stop before opening the doer.
2. Open the deer. If the main wash detergent dispenser is still
closed, add the item.
& Close the doec but de not latch it. Wait 30 seconds for the air
in the dishwasher to warm up. This reduces the amount of
moisture escaping from the vent when restarting a cycle.
4. Close the doer fimnly until it latches. The dishwasher resumes
the cycle after about a 5-second pause.
Option Selections
You can customize your cycles by pressing an option, if you
change your mind, press the option again to turn the option off.
Select a different option if desired.
You can change an option anytime before the selected option
begins. For example, you can press an unheated drying option
any time before drying begins.
Press START to use the same cycle and option(s) as the previous
wash cycle.
NOTE: If the last cycle you completed was a rinse cycle, when
you press Start, the dishwasher runs the last full wash cycle and
options.
Hi Temp Scrub
Select this option to heat the water during parts of the cycle. Hi
Temp Scrub heats the water to 145"F (63_'C) in the main wash.
Heating the water helps improve washing results.
This option adds heat, water and wash time to the cycle.
A,
NOTE: Hi Temp Scrub is an option with Pots Pans and Normal
Wash.
Sani Rinse
Select this option to raise the water temperature in the final rinse
to approximately 155"F (68_C) for 10 minutes. Sani Rinse adds
heat and time to the cycle. In the Normal cycle this high-
temperature rinse sanitizes your dishes and glassware in
accordance with the NSF Protocol P153 Sanitization and
Cleaning Performance of Household Spray-Type Dishwashers.
NOTE: Sani Rinse is an option with Pots Pans, Normal Wash and
Water Miser.
Air Dry
Select this energy-saving option to dry without heat. Air drying is
useful when loads contain plastic dinnerware that may be
sensitive to high temperatures.
LOCKON
The dishes take longer to dry and some spotting can occur. For
best drying, use a liquid rinse aid. Some items (such as plastics)
may need towel drying.
NOTE: Quick Rinse automatically uses this option. Air Dry is an
option with all other cycles.
Lock On
Use the Lock On to prevent unintended use of the dishwasher.
You can also use the lock feature to prevent unintended cycle or
option changes during a cycle.
LOCK ON
When LOCK ON is lit, all buttons are disabled.
NOTES:
• The dishwasher door can be opened while the controls are
locked.
•
You can turn on the Lock while the dishwasher is running.
TO turn on the Lock
Press and hold
LOCK O N
for 4 seconds. LOCK ON glows.
If you press any pad while your dishwasher is locked, the light
flashes 3 times.
TO turn off _e Lock
Press and hold AIR DRY for 4 seconds. The light turns off.
Delay Hours
Select this option to run your dishwasher at a later time or during
off-peak hours.
To delay _e start
1. Close the door.
2. Select a wash cycle and options.
& Press DELAY HOURS 1 time for a 2-hour delay, 2 times for a
4-hour delay, or 3 times for a 6-hour delay.
HOURS
2 4 6
@
The number glows above Delay Hours. The dishwasher starts
the cycle in the selected number of hours.
4. Press START.
NOTE: To cancel the delay, press OANCEWDRAIN until all Delay
Hours lights are off.
14