Honeywell FBII OMNI 600 User Manual page 21

OMNI-LCD or OMNI-LCD-US: Press and hold down the
/
CODE
key to toggle the display between:
Backlight 120s time out .... and .... Backlight Always On
Press the [✱] key to exit this Backlight menu.
KEYPAD SOUNDER
The sounder (or loudspeaker) housed inside the keypad emits (annunciates) sounds
according to the condition of the security system. If you are using an OMNI-KP,
OMNI-KP-US, OMNI-LCD, or OMNI-LCD-US keypad, the sounds from the keypad
sounder can be controlled.
To change the keypad sounder:
OMNI-KP or OMNI-KP-US: Press the
at the same time and hold down for two seconds until you hear a beep. Press any
key (except the
0 = Sounder off
Press the [✱] key to exit the sounder menu.
OMNI-LCD or OMNI-LCD-US: There are four modes available in the Sounder Menu.
They are as follows:
• On – Normal Sounder Keys (all sounds on)
• Key – Only Key Clicks
• Fire – Only Fire Sounder (temporal sounder – not supported by all systems)
• Off – No Sounds at all
To use the OMNI-LCD or OMNI-LCD-US sounder menu:
1. Press the
BYPASS
hold down for two seconds. This accesses the Sounder Menu.
1
2. Press the
desired mode).
2
3. Press the
appears on the display).
3
4. Press the
appears on the display).
6
5. Press the
Miscellaneous Commands (cont)
keys at the same time for about two seconds. Press the
BYPASS
6
key) to toggle the sounder on or off.
1 = Sounder on
/ and
CODE
key to toggle through the four modes listed above (stop at
key to toggle through the sounder volume choices (high or low
key to adjust the sound of the key acknowledge (Ack H or L
key to exit the Sounder Menu.
INSTANT
/ and
CODE
/ keys at the same time and
/ and
1
/ keys
- 21 -