Miscellaneous Commands - Honeywell FBII OMNI 600 User Manual

Miscellaneous Commands

TO DELETE A USER CODE
To delete a user, press the CODE/
master user code. Enter the user number, then press [#] to delete. For example, to
delete user 3, do the following:
/
CODE
NOTE: User no. 1, the master user, cannot be deleted but it can be changed using
the ADD OR CHANGE A USER CODE procedure.
DURESS
Your system can be programmed to send an emergency signal to the central station
if you are forced to enter the premises under threat. If you choose to include this
feature, assign codes to user 15 (OMNI400 and OMNI600), 31 and 32 (OMNI624),
or 60-64 (OMNI848), which are dedicated to this function, if programmed. Use
these codes only under a duress circumstance.
QUICK ARMING
If programmed by your installer, Quick Arming allows you to arm the system in the
AWAY mode without entering a user code.
#
Press
NOTES:
• Disarming your system always requires a valid user code.
• This system can be programmed by the installer for the AUTOSTAY feature
which automatically bypasses interior zones if you arm the system and do not
exit through a delay zone during exit time.
QUICK FORCED ARMING
If programmed by your installer, Quick Forced Arming allows you to arm the
system in the AWAY mode by automatically bypassing all zones that are not ready.
#
Press
NOTES:
• A valid user code is still required to disarm the system.
• This system can be programmed by the installer for the AUTOSTAY feature
which automatically bypasses interior zones programmed for AUTOSTAY if you
arm the system and do not exit through a delay zone during exit time.
UL NOTE: This feature is disabled on UL installations.
- 16 -
Master User Code
1
, then .
2
, then .
button followed by the 4-digit (or 6-digit)
User ID
03
# to delete
[#]