Honeywell FBII OMNI 600 User Manual page 18

Miscellaneous Commands (cont)
CHANGE PARTITION (OMNI624 and OMNI848 ONLY)
To arm or disarm other partitions from your keypad, enter the following:
#
where: 1-3* = the desired partition you wish to change to
0
9
* Partition 3 is available on the OMNI848 ONLY.
SET AUTO-ARM TIME
Set Auto-Arm Time lets you set the time your system will automatically arm.
To set the Auto On Time:
#
Press
The keypad will prompt you for the required entries.
TO VIEW AUTOARM TIME
To view the autoarm time for the partition to which the keypad is assigned, press:
#
+
AUTOARM TIME:
(The user code is not required if so programmed by installer.)
DOOR STRIKE
To activate door strikes:
#
Press
If programmed, certain user codes can also be used to open a door. See your installer
for door numbers.
- 18 -
0
[1-3, 0, 9]
When you enter a partition number (1-3*), the system displays the
current armed state for that partition. You can then arm or disarm
the partition by entering the arming/disarming command.
= arms all partitions
= disarms all partitions
5 4
+ +
5 2
+ + user code with authority level 1 or 2.
05:00PM
5 7
+ +
+ user code + hour 00-23 + minute 00-59.
+ Door No.