Honeywell FBII OMNI 600 User Manual page 11

WHEN THE SYSTEM IS NOT READY
If the system is not ready to be armed, the READY/
display will show which zone or zones are not ready. The following conditions will
be indicated by the zone lights (LED keypad) or described on the display:
Fast Blink ............................... Alarm or tamper condition
Slow Blink/Low Intensity ... Bypass
Slow Pulse .............................. Trouble, problem with RF receiver, or low battery
Solid On ................................... Zone faulted
Example: If the READY/
alarm sensor on Zone 1 is faulted. This might mean that a door is open or someone
is walking in view of a motion sensor. Check all sensors on Zone 1 and resolve the
problem. When all sensors are restored, the READY/
zone light will go out. In this example, the display shows:
NOT READY
Determine which zone or zones are not ready, resolve the problem, and arm the
system normally. If the problem cannot be resolved, you may bypass the zone that
is not ready. Bypassing should only be done if the problem on the zone cannot be
resolved, OR if you intentionally wish to leave the zone disarmed. For example, you
would leave the zone disarmed if you plan to keep the window open for ventilation.
Zones that are bypassed are not protected when the system is armed. See
TO BYPASS A ZONE on page 13 for a description of the procedure.
TO ARM THE SYSTEM AND STAY INSIDE
To arm the perimeter portion of your burglar alarm and move around freely inside
the premises, use the STAY mode.
Check to make sure the system is ready. When it is ready, press:
/
STAY
When the system has been armed successfully, the ARMED/
and the following is displayed:
LCD Keypad:
ON: STAY
REMEMBER: You must disarm the system or press
the "quick exit" if you want to open the door or leave the premises after the exit
time has expired. Quick Exit restarts the exit time without disarming the system.
✔
light is not lit and the Zone 1 light is solid on, an
NOT RDY
and
FRONT DOOR
followed by your user code.
Fixed-Word Keypad:
STAY/
Arming the System (cont)
✔
light will be off and the
✔
light will come on and the
ZN 1
(STAY) light is lit
LED Keypad:
ARM/ and STAY/
/
STAY
LEDs lit
to initiate
- 11 -