Honeywell FBII OMNI 600 User Manual page 13

TO BYPASS A ZONE
The Bypass function excludes a zone of protection from the security system until it
is unbypassed (either by using the unbypass procedure or when you disarm the
system). Bypassing can only be done while the system is disarmed.
NOTE: 24-hour zones may be bypassed, but can only be unbypassed if the zone is
not faulted (condition has been cleared).
Press the BYPASS/
to be bypassed, as follows:
/
BYPASS
†
If the Quick Bypass feature has been enabled by the installer, do not enter the
user code when bypassing zones.
NOTE: Bypassed zones are NOT protected when the system is armed. After the
bypass command has been accepted, the keypad sounds one long beep, and the
following is displayed:
LCD Keypad:
BYPASSED: ZN 01
FRONT DOOR
To Bypass multiple zones, within 10 seconds of the BYPASS/
Zone No. entry, enter:
/
BYPASS
This command can be repeated for each zone to be bypassed.
TO UNBYPASS A ZONE
Pressing the BYPASS/
To unbypass a zone, the system must be disarmed. (Also note that 24-hour zones
cannot be unbypassed if they are faulted.) To unbypass a zone(s), repeat the bypass
function as follows:
/
BYPASS
† If the Quick Bypass feature has been enabled by the installer, do not enter the
user code when unbypassing zones.
After unbypassing, the zone display will show the state of the zones.
button. Then enter your user code and the zone number
followed by your user
code †
Fixed-Word Keypad:
BYPASS/
Zone number displayed
+ Zone No.
button returns a bypassed zone to normal operation.
followed by your user
code †
Arming the System (cont)
LED Keypad:
Zone LEDs of the zone(s)
bypassed slowly blink
+ Zone
No.
+ User Code +
+ Zone
No.
- 13 -