Installation; Attaching The Printer Rear Support; Connecting The Power Cord - Toshiba B-SA4TM Series Owner's Manual

2. PRINTER SETUP

2.1 Installation

2.1.1 Attaching the Printer
Rear Support
NOTE:
The Printer Rear Support can be
attached in either way of A or B.
But A is more stable than B.
A
2.2 Connecting the
Power Cord
CAUTION!
As a Power Cord is not supplied
with the printer, please purchase
an approved on that meets the
safety standard of each country.
(Refer to APPENDIX 3.)
To insure the best operating environment, and to assure the safety of the
operator and the equipment, please observe the following precautions.
•
Operate the printer on a stable, level, operating surface in a location
free from excessive humidity, high temperature, dust, vibration or
direct sunlight.
•
Keep your work environment static free. Static discharge can cause
damage to delicate internal components.
•
Make sure that the printer is connected to a clean source of AC
Power and that no other high voltage devices that may cause line
noise interference are connected to the same mains.
•
Assure that the printer is connected to the AC mains with a three-
prong power cable that has the proper ground (earth) connection.
Attach the supplied Printer Rear Support to the bottom of the printer back
with the SMW-4x8 screw, as shown in the picture below.
B
Printer Rear Support
1. Make sure that the printer Power Switch is in the OFF ( ) position.
Connect the Power Cord to the printer as shown in the figure below
2. Plug the other end of the Power Cord into a grounded outlet as shown
in the figure below.
Power Cord
SMW-4x8
Power Switch
[Example of US Type]
E2- 2
ENGLISH VERSION EO1-33047
2.1 Installation
Power Cord
Power Cord
[Example of EU Type]