Toshiba B-SA4TM Series Owner's Manual page 36

2. PRINTER SETUP
2.7.1 Parameter Setting
(Cont.)
When ON is selected, pressing the [PAUSE] key will result that the LCD
Message Display shows the stop position fine adjustment value setting
screen.
<2>PARAMETER SET
POSITION +0.0mm
[RESTART]
[FEED]
[FEED] key: Pressing the [FEED] key one time causes a –0.1mm change,
up to –5.0 mm.
[RESTART] key: Pressing the [RESTART] key one time causes a +0.1mm
change, up to +5.0 mm.
After selecting an auto forward wait, press the [PAUSE] key.
(10) Control Code Selection
This parameter is to choose a Control Code.
When "<2>PARAMETER SET" appears, press the [PAUSE] key until
the following display appears.
<2>PARAMETER SET
CODE AUTO
Use the [FEED] or [RESTART] key to select a desired option.
[RESTART]
[FEED]
When "CODE MANUAL" is selected and the [PAUSE] key is pressed,
the LCD display will show the setting screen of CONTROL CODE1 to
CONTROL CODE3 as follows.
<2>PARAMETER SET
CONTROL CODE1 1B
[RESTART]
[FEED]
E2-22
ENGLISH VERSION EO1-33047
2.7 Setting an Operating Environment
POSITION +5.0mm
POSITION +0.0mm
POSITION -5.0mm
CODE AUTO
CODE ESC,LF,NUL
CODE{|}
CODE MANUAL
CONTROL CODE1 FF
CONTROL CODE1 FE
CONTROL CODE1 FD
CONTROL CODE1 02
CONTROL CODE1 01
CONTROL CODE1 00
Automatic selection
Manual selection
Manual selection
Control codes should
be specified.