Toshiba B-SA4TM Series Owner's Manual page 42

2. PRINTER SETUP
2.7.1 Parameter Setting
(Cont.)
NOTE:
If the printer and the PC are
connected by USB, plug & play will
be automatically enabled, regardless
of the setting of this parameter.
(21) Plug & Play Selection
This parameter is to choose whether to enable a Plug & Play function.
When "<2>PARAMETER SET" appears, press the [PAUSE] key until
the following display appears.
<2>PARAMETER SET
PLUG & PLAY OFF
Use the [FEED] or [RESTART] key to select a desired option.
[RESTART]
[FEED]
After selecting a Plug & Play, press the [PAUSE] key.
(22) Label End/Ribbon Error Selection
This parameter is to choose a printing process when a label end or ribbon
error is detected.
When "<2>PARAMETER SET" appears, press the [PAUSE] key until
the following display appears.
<2>PARAMETER SET
LBL/RBN END TYP1
Use the [FEED] or [RESTART] key to select a desired option.
[RESTART]
[FEED]
After selecting a Label End/Ribbon Error type, press the [PAUSE] key.
E2-28
ENGLISH VERSION EO1-33047
2.7 Setting an Operating Environment
PLUG & PLAY OFF
PLUG & PLAY ON
LBL/RBN END TYP1
TYPE1: When a label end/ribbon error is
detected in the middle of printing, printing is
immediately paused.
LBL/RBN END TYP2
TYPE2: When a label end/ribbon error is
detected in the middle of printing, the printer
prints the half-finished label as far as
possible, and stops when the next label is at
the home position.
Unavailable
Available