Download  Print this page

Advertisement

APPENDIX 2 INTERFACE

APPENDIX 2 INTERFACE
NOTE:
To prevent radiation and reception of electrical noise, the interface cables must meet the following requirements:
• In case of a parallel interface cable or serial interface cable, fully shielded and fitted with metal or metallised
connector housings.
• Keep as short as possible.
• Should not be bundled tightly with power cords.
• Should not be tied to power line conduits.
• A parallel interface cable to be used should conform to IEEE1284.
Parallel interface (Centronics)
Mode:
Data input method: 8 bit parallel
Control signal:
Data input code:
Receive buffer:
Conforming to IEEE1284
Compatible mode (SPP mode), Nibble mode
SPP Mode
Nibble Mode
nStrobe
HostClk
nAck
PtrClk
Busy
PtrBusy
Perror
AckDataReq
Select
Xflag
nAutoFd
HostBusy
nInit
nInit
nFault
nDataAvail
nSelectIn
IEEE1284Active
ASCII code
European 8 bit code
Graphic 8 bit code
JIS8 code
Shift JIS Kanji code
JIS Kanji code
1M byte
EA2- 1
ENGLISH VERSION EO1-33047
APPENDIX 2 INTERFACE

Advertisement

Table of Contents

This manual is also suitable for:

B-sa4tp series

Comments to this Manuals

Symbols: 0
Latest comments: