Unit Display And Operation Selector - Sanyo CG1411 Service Manual

IMPORTANT
Avoid using radio equipment
such as mobile phones near
(within 1 m of) the indoor unit.
Some radio equipment may
cause the unit to malfunction.
If the trouble occurs, disconnect
power and restart the air
conditioner after a few minutes.
REMOTE CONTROL
Operation selector
ON position
OFF position
TEST position
CAUTION
OPERATION lamp
TIMER lamp
8

Unit Display and Operation Selector

INDOOR UNIT
This section picks up infrared signals from the remote control unit
receiver (transmitter).
This position is for operating the air conditioner with the wireless
remote control unit.
Set the selector normally in this position.
Switch the selector to the OFF position if you are not going to use
the air conditioner for a few days or longer.
The OFF position does not disconnect the power. Use the main
power switch to turn off power completely.
This position is used only when servicing the air conditioner.
To operate in the TEST position, first select DRY, COOL, or HEAT
•
mode with the selector in the ON position, and then switch the
selector to the TEST position. However, the air conditioner will
not operate when set to the TEST position if it has been stopped
by setting to the OFF position.
During TEST mode, the OPERATION lamp and timer lamp flash,
•
and remote control operation does not work.
Do not set at the TEST position for normal operation.
This lamp lights when the system is in the continuous DRY,
COOL, FAN and HEAT mode.
This lamp lights when the system is being controlled by the timer.
Operation selector
ON
OFF
TEST
Remote control receiver
OPERATION lamp
OPERATION
TIMER lamp
TIMER
OI-202-08EG