Unit Display And Operation Selector - Sanyo KS2462R Instruction Manual

IMPORTANT
Avoid using radio equipment
such as mobile phone near
(within 4 ft. of) the indoor unit.
Some radio equipment may
cause the unit to malfunction.
If the trouble occurs, dis-
connect power and restart the
air conditioner after a few
minutes.
REMOTE CONTROL
Operation selector
OFF position
TEST position
OPERATION lamp
TIMER lamp
6

Unit Display and Operation Selector

OPERATION lamp
This section picks up infrared signals from the remote control unit
receiver (transmitter).
ON position This position is for operating the air conditioner with the wireless
remote control unit.
Set the selector normally in this position.
Switch the selector to the OFF position if you are not going to use
the air conditioner for a few days or longer.
The OFF position does not disconnect the power. Use the main
power switch to turn off power completely.
This position is used only when servicing the air conditioner.
Do not set the operation selector at the TEST position for normal
CAUTION
operation.
This lamp lights when the system is in the continuous DRY and
COOL mode.
This lamp lights when the system is being controlled by the timer.
INDOOR UNIT
Remote control
TIMER lamp
receiver
OPERATION TIMER
ON
OFF
TEST
Operation selector
OI-508-06EG