Unit Display And Operation Selector - Sanyo SAP-KCRV243GJH Technical & Service Manual

8. Unit Display and Operation Selector

IMPORTANT
Avoid using radio equipment such as mobile phone near
(within 1 m) the remote control receiver. Some radio
equipment may cause malfunction of the unit.
If the trouble happens, disconnect power and restart the
air conditioner after a few minutes.
REMOTE CONTROL
Operation selector
WARNING
TEST position
CAUTION
DEMO position
OPERATION lamp
SERVICE Lamp
KRV 243
KRV 303
INDOOR UNIT
TIMER
lamp
This section picks up infrared signals from the remote control unit (transmitter).
receiver
This position is for operating the air conditioner with the wireless remote control unit.
ON position Set the selector normally in this position.
OFF position Switch the selector to the OFF position if you are not going to use the air conditioner
for a new days or longer.
The OFF position does not disconnect the power. Use the main power switch
to turn off power completely.
This position is used only when servicing the air conditioner.
Do not set at the TEST position for normal operation.
This position is used only when setting address of the remote control unit.
This lamp lights when the system is in the continuous AUTO (red, orange or
green), HEAT (red), DRY (orange) and COOL (green) mode.
TIMER lamp This lamp lights when the system is being controlled by the timer.
When a fault occurs in the air conditioner, this lamp turns on or flashes in
combination with the other two lamps to indicate the type of fault.
Operation selector
OPERATION
lamp
TIMER OPERATION
47
DEMO.
TEST
ON
OFF