Unit Display And Operation Selector - Sanyo KHS0951 Instruction Manual

INDOOR UNIT
KHS1852
OPERATION lamp TIMER lamp
OPERATION
STANDBY TIMER
STANDBY lamp
IMPORTANT
Avoid using radio equipment such as mobile phones
near (within 4 ft. of) the indoor unit. Some radio
equipment may cause the unit to malfunction.
If the trouble occurs, disconnect power and restart the
air conditioner after a few minutes.
Remote control receiver
Operation selector
ON position
OFF position
TEST position
CAUTION
OPERATION lamp
TIMER lamp
STANDBY lamp
6

Unit Display and Operation Selector

ON
OFF
TEST
Operation selector
Remote control
receiver
This section picks up infrared signals from the remote control unit
(transmitter).
This position is for operating the air conditioner with the wireless
remote control unit.
Set the selector normally in this position.
Switch the selector to the OFF position if you are not going to use
the air conditioner for a few days or longer.
The OFF position does not disconnect the power. Use the main
power switch to turn off power completely.
This position is used only when servicing the air conditioner.
Do not set the operation selector at the TEST position for normal
operation.
This lamp lights when the system is in the continuous HEAT,
DRY and COOL mode.
This lamp lights when the system is being controlled by the timer.
This lamp lights during the warm up period for heating and
when the system is defrosting.
INDOOR UNIT
KHS0951
KHS1251
TEST
Remote control receiver
OPERATION
TIMER
STANDBY
STANDBY lamp
TIMER lamp
OPERATION lamp
Operation selector
ON
OFF
OI-351-06EG