Operating Instruction - Sanyo CG1411 Service Manual

For Your Safety Read Before Operation
A. This appliance is supplied natural gas for heat
source into outdoor section.
Read the following safety information before
operation and/or maintenance is performed.
B. This appliance dose not have a pilot light. It is
equipped with an ignition device which
automatically lights the burner.
Do not try to light the burner by hand.
C. BEFORE OPERATING: Smell around the appliance
area for gas. Be sure to smell next to the floor
because some gas is heavier than air and will
settle on the floor.
WHAT TO DO IF YOU SMELL GAS
Do not try to light any appliances.
•
Do not touch any electric switch; do not use
•
any phone in your building.
Immediately call your gas supplier from a
•
neighbor's phone.
Follow the gas supplier's instructions.
If you reach your gas supplier, call the fire
•
department.
D. Use only your hand to push in or turn the gas
control knob. Never use tools. If the knob will not
push in or turn by hand, don't try again call a
qualified service technician. Attempting to repair
the appliance may result in a fire or explosion.
E. Do not use this appliance if any part is
underwater. Immediately call a qualified service
technician to inspect the appliance and to replace
any part of the control system and any gas
control which has been underwater.
2
WARNING:
If you do not follow these instructions exactly, a fire or
explosion may result causing property damage,
personal injury or loss of life.

Operating Instruction

1. STOP! Read the safety information above in this
manual.
2. Manual Shutoff valve shall be turned off when
heating is not operating.
3. Turn off the electric power supply when the
manual shutoff valve is turn on. Wait five
minutes, and then smell for gas, including near
the floor.
If you smell gas, STOP! Follow ''C'' in the safety
information above on this manual.
If you don't smell gas, go to the operating
instructions.
Installation Instruction
The installation must conform with local codes or, in
the absence of local code, with the National Fuel
Gas Code:
ANSI Z223.1/NFPA 54
and National Electric Code:
ANSI/NFPA 70.
OI-202-02EG