Renault Modus Handbook page 41

CHILD SAFeTy: fitting a child seat
X = Seat not suitable for fitting child seats.
U = Seat which allows a child seat with "Universal" approval to be attached by seat belt; check that it can be fitted.
IUF/IL = On equipped vehicles, seat which allows a child seat with "universal/semi-universal or vehicle specific" approval to be
fitted using the ISOFIX system; check that it can be fitted correctly.
L = Seat which allows certain booster cushions to be fitted. Consult the booklet available from an approved Dealer.
(3) Only a rear-facing child seat can be fitted in this seat: position the vehicle seat as far back and raise it as much as possible,
and tilt the seatback slightly (approximately 25°).
(4) A carrycot can be installed across the vehicle and will take up at least two seats. Position the child with his or her feet nearest
the door.
(5) Push the vehicle seat fully forwards to install a rear-facing child seat, then push it back as far as possible without allowing it to
make contact with the child seat.
(6) Forward-facing child seat; position the seatback of the child seat in contact with the seatback of the vehicle seat. Adjust the
headrest, or remove it if necessary. Do not push the seat in front of the child more than halfway back on its runners and do not
recline the seatback more than 25°.
(7) Before fitting a child seat (excluding carrycot) on vehicles fitted with TRIPTIC bench seats, it is recommended that the bench
seat is put in the 2-seater position if possible (refer to information on "Rear bench seat functions" in section 3). In the 2 or
3-seater positions, move the bench seat as far back as possible, checking that the floor support of the child seat is resting on
the floor in accordance with the child seat instructions.
(8) It is not possible to fit a booster cushion using the ISOFIX anchorage points and the seat belt on the rear side seat when the
TRIPTIC bench seat is in the 3-seater position.
(4/6)
1.35