Adding Items During A Cycle; Option Selections - Kenmore 665.16532 Use & Care Manual

Afterthefirstfill ofa cycle
1.
Press
71 / l_,i
The display shows
3.
4.
5.
Your dishwasher starts a 2-minute drain (if needed). Let the
dishwasher drain completely. The light turns off after 2
minutes.
NOTE: If your dishwasher does not need draining, the light
turns off.
Check the detergent dispensers. They must be filled properly
for the new cycle.
Close the door.
Press a new cycle and/or options.
Press STAR]_
You can add an item anytime before the main wash starts. Open
the door and check the detergent dispenser. If the cover is still
closed, you can add items.
To add items
1. Lift up the door latch to stop the cycle. Wait for the spraying
action to stop before opening the door.
2. Open the door. If the detergent dispenser cover is still closed,
add the item.
3. Close the door firmly until it latches. The dishwasher resumes
the cycle after about a 5-second pause.
You can customize your cycles by pressing an option. If you
change your mind, press the option again to turn the option off,
or select a different option if desired.
You can change an option anytime before the selected option
begins. For example, you can press an unheated drying option
any time before drying begins.
Press START to use the same cycle and option(s) as the previous
wash cycle.
NOTE: If the last cycle you completed was a rinse cycle, when
you press Start, the dishwasher runs the last full wash cycle and
options.
Hi Temp Scrub
Select this option to increase the target water temperature during
the wash portions of the cycle. Hi Temp Scrub raises the target
water temperature to 145°F (63°C), in the main wash. In the Anti
Bacterial and Pots Pans cycles, Hi Temp Scrub also raises the
target water temperature to 135°F (57°C) in the pre-wash.
Heating the water helps improve washing results. Hi Temp Scrub
is useful when loads contain baked-on food.
This option adds heat and wash time to the cycle. When Hi Temp
Scrub is used with the Anti Bacterial and Pots Pans cycles, water
is also added to the cycle.
L(}R!i_
NOTE: Hi Temp Scrub is an option with Anti Bacterial, Pots Pans
and Normal Wash.
Sani Rinse
Select this option to raise the water temperature in the final rinse
to approximately 160°F (71°C). Sani Rinse adds heat and time to
the cycle. This high temperature rinse sanitizes your dishes and
glassware in accordance with NSF Standard 184 for Residential
Dishwashers. Certified residential dishwashers are not intended
for licensed food establishments.
o
SAH
8NS
NOTE: The Anti Bacterial cycle automatically uses this option.
Sani Rinse is an option with SmartWash, Pots Pans and Normal
Wash. Only these sanitization cycles have been designated to
meet the NSF requirements.
Air Dry
Select this option to dry without heat. Air drying is useful when
loads contain plastic dinnerware that may be sensitive to high
temperatures.
O
o£i{ {)N
The dishes take longer to dry and some spotting can occur. For
best drying, use a liquid rinse aid. Some items (such as plastics)
may need towel drying.
NOTE: Air Dry is an option with all cycles, except Quick Rinse.
Lock On
Use the Lock On to prevent unintended use of the dishwasher.
You can also use the lock feature to prevent unintended cycle or
option changes during a cycle.
o()I_ ON
When LOCK ON is lit, all buttons are disabled.
NOTES:
• The dishwasher door can be opened while the controls are
locked.
• You can turn on the Lock while the dishwasher is running.
15