Troubleshooting; If You Get A Black Or Blank Screen; Not Receiving A Digital Signal During Installation/Set Up - Dish Network DTVPAL User Manual

YOUR DTVPAL DIGITAL-TO-ANALOG TV
CONVERTER
DTVPAL ToP TiPs
QUICK TROUBLESHOOTING TIPS
if You Get a B_ack or B_ank Screen
Make sure your DTVPal is powered on. There should be a green light on
the front panel of your DTVPal. If not, press the POWER button on your
DTVPal remote control.
• Make sure your TV is on the correct channel for viewing your DTVPal. Your
TV needs to be on either channel 3 or 4 (if connected using coax cable) or
a video input (if connected using RCA cables).
• Your DTVPal might need a simple "reset". Simply unplug the DTVPal from
your power outlet for 30 seconds and then plug it back in. Your DTVPal will
reset and should be ready to use again within minutes.
Not Receiving a Digital Signal During Your Installation/
Set Up
Please note: Not all broadcasters are currently broadcasting a digital signal and
the source of the digital signal may move at any time. Go to
www.antennaweb.orq or contact your local broadcaster to find out which
channels in your area are broadcasting a digital signal.
• If you are not able to receive a
digital TV signal for ANY of your
local channels and you see "The
receiver is unable to detect a
signal in your area" message on
your screen, it is possible that
you do not have the correct over-
the-air antenna to receive a
digital signal or are out of range
for digital broadcasts. Go to www.antennaweb.orq for more information on
which over-the-air antenna is best for your area or visit your nearest
electronics retailer.
If you are not able to receive a digital TV signal for SOME of your local
channels you may simply need to adjust your over-the-air antenna or get
an over-the-air antenna that is optimized for your area. Go to
www.antennaweb.or.q for more information on which over-the-air antenna
is correct for your area or visit your nearest electronics retailer.
Page vii