To navigate through the Installation Wizard,
use the SELECT button on your DTVPal
remote control to choose the highlighted
(orange) on-screen option. To highlight other
options, use the ARROW buttons.
to begin the Installation
The Installation Wizard scans for local digital
After the channel scan completes, you wilt be taken to the Set Time Zone
screen. Use the UP and DOWN ARROW buttons to find your time zone
and to set if your area follows Daylight Savings time. Select Next once
you've made these settings and to go to the next step.
The Channel 3-4 Setup screen is used to change the output channel of the
D-I-VPaI's TV SET OUT connection. The channel setting on the Channel 3-4
Setup screen must match your TV's channel. If you have a local or cable
channel that broadcasts on channel 3, be sure to change this setting to
channel 4. If you do this, you will also need to change your TV channel to 4.
Use the ARROWS or NUMBER PAD to enter your ZIP code. Select Next.
The DTVPal begins to
download the Program
Guide information. This
takes a few minutes. After
the Program Guide has
downloaded, the DTVPal
will exit out to a channel.
DTVPal is now installed and
ready to use! To start
watching TV, press either
the UP or DOWN ARROW buttons to change channels, or enter the
channel number using the NUMBER PAD.
Note: Some broadcasters choose to send several channels in their
broadcast range rather than just a single channel. These additional
channels are referred to as sub-channels, and are identified by a dash and
then a number (for example, channel 9-2 is a sub-channel of channel 9). To
change to a sub-channel, enter "0" before entering the channel number.
For example, to change to channel 9-2, enter "0092" on the NUMBER PAD.