Dish Network DTVPAL User Manual page 30

YOUR DTVPAL DIGITAL-TO-ANALOG TV
CONVERTER
TROUBLESHOOTING
Symptom
You're receiving a 1
"signal toss"
message on
some or all
2
channels.
Troubleshooting Steps
Try a different channel. Sometimes, just one channel
may be experiencing a problem, while other channels are
fine.
Verify that the cable connecting to the OVER THE AIR
ANTENNAIN connection is hand tight, and is connecting
to your over-the-air antenna.
Verify that your over-the-air antenna is still in place, and
does not appear to have moved. If the antenna is moved
out of alignment, you may receive signal loss messages
on some or all of your channels.
Try resetting your DTVPal. Press the POWER button on
the DTVPaI's remote control to turn it off, then unplug the
your DTVPal from the power outlet for 15 seconds, plug it
back in, and turn it back on.
Check the signal strength on your over-the-air channels.
Using your DTVPaI's remote control, press MENU, select
Setup, System Setup, Channel Setup, then Add a
New Channel. Find the channel that is experiencing
problems, and verify that it has a strong signal. Channels
with signal strength below 54% will experience loss of
video.
Your over-the-air antenna may need to be adjusted.
Contact your local retailer for assistance. If you want to
try adjusting the antenna yourself, refer to
www.antennaweb.org for antenna recommendations and
antenna alignment information.
Page 20