Updating Tv Guide On Screen And Guide Plus Setup; Entering Your Location; Set Up Your Device - Dish Network DTVPAL User Manual

YOUR DTVPAL DIGITAL-TO-ANALOG TV
CONVERTER
TV GUIDE ON SCREEN OR GUIDE PLUS SETUP
Updating TV Guide On Screen and Guide PNus Setup
After connecting your DTVPal to your TV Guide On Screen or Guide Plus-
enabled device, use these steps to complete the setup.
Note: The menu options on your Guide-enabled device may differ from the
ones described here.
1 Using the remote control for your Guide-enabled TV, DVD recorder, or
VCR, press GUIDE to open your Guide Listings screen.
2 On the Service Bar, select Setup, then Change System Settings.
3 If available, select No, repeat setup. Otherwise, follow the on-screen
prompts.
Entering Your Location
The Guide uses setup information to provide TV show listings and channel
lineups for your area.
1 Select USA as the country.
2 Use the remote control NUMBER PAD or the UP and DOWN ARROWS to
enter the Substitute ZIP Code for your area. See page 28 for the ZIP code
listing.
Set Up Your DTVPal
For your Guide to communicate with your DTVPal, the Guide must be set up as
though the DTVPal is a cable box, even though you do not have cable service.
Use these steps to finish setting up your DTVPal.
Select Cable with a Cable Box or Yes I have cable. 1
2
3
4
5
6
7
If asked, select the type of audio/video input you used to connect your
DTVPal to your Guide-enabled device, then follow the on-screen prompts.
If a connection diagram displays, verify the G-LINK cable is connected as
shown.
For brand of cable box, select Scientific Atlanta.
Follow the on-screen instructions and verify that your DTVPal changed
channels.
When asked if the device has tuned to Channel 9, select Yes.
On the confirmation screen, select Yes, continue/finish setup process. If
you are asked about setting up a VCR, select the appropriate answer for
your installation.
Page 25