Download  Print this page

DISH NETWORK DTVPAL User Manual Page 6

Digital-to-analog tv converter.
Hide thumbs

Advertisement

YOUR DTVPAL
DIGITAL-TO-ANALOG TV
CONVERTER
IMPORTANT
SAFETY
INSTRUCTIONS
Note to Installer:
This reminder is provided to call the installer's attention to Article
810 section II of the National Electrical Code (NEC) that provides guidelines for proper
grounding and, in particular, specifies that the cable ground shall be connected to the
grounding system of the building as close to the point of cable entry as practical.
Example
of Antenna
Grounding
National
Electrical Code, 2008
Antenna
Antenna
• Discharge
Unit
(NECSection 810-20)
lding
(NECSection 810_21 )
Ground
Clamp
_Power
Service Grounding
Electrode
System
(NECArt. 250,Part H)
Do not locate the antenna near overhead light or power circuits, or where it can fall into
such power lines or circuits. When installing the antenna, take extreme care to avoid
touching such power lines or circuits, as contact with them can be fatal.
Proper
Care of Your Equipment
Locate the TV converter in an open, well-ventilated
area.
If the TV converter is cold to the touch, do not plug it in immediately. Let it sit unplugged
at room temperature for at least 30 minutes before plugging it in.
Always handle the TV converter and power adapter carefully.
Unplug the power adapter from the AC power outlet before cleaning.
Always turn the TV converter off and unplug it before moving it.
The use of accessories or attachments not recommended
by the TV converter
manufacturer
will void the Limited Warranty.
Use an outlet that contains surge suppression or ground fault protection. During an
electrical storm or when the TV converter is left unattended and unused for long
periods of time, unplug the adapter from the wall outlet, and disconnect the lines
between the TV converter and the antenna. This will provide additional protection
against damage caused by lightning or power line surges.
Page iv

Advertisement

Chapters

Table of Contents

   Related Manuals for DISH NETWORK DTVPAL

Comments to this Manuals

Symbols: 0
Latest comments:
  • Karla Morrison Jun 20, 2019 03:27:
    Do I need to rescan on the 21 St of June.
  • Terrence Agpawa Nov 10, 2016 03:01:
    How do I order a replacemen​t remote control?