Error Messages; Optical Drive Problems; Problems Writing To An Optical Drive; Hard Drive Problems - Dell Vostro 220s Service Manual

Run the Dell Diagnostics —

Optical drive problems

NOTE: High-speed optical drive vibration is normal and may cause noise, which does not indicate a defect in the drive
or the media.
NOTE: Because of different regions worldwide and different disc formats, not all DVD titles work in all DVD drives.
Adjust the Windows volume control —
Click the speaker icon in the lower-right corner of your screen.
Ensure that the volume is turned up by clicking the slidebar and dragging it up.
Ensure that the sound is not muted by clicking any boxes that are checked.
Check the speakers and subwoofer —

Problems writing to an optical drive

Close other programs —
interrupted, an error occurs. Try closing all programs before you write to the optical.
Turn off standby mode in Windows before writing to a disc —
Support for information on power management modes.

Hard drive problems

Run Check Disk —
Windows XP:
1. Click Start and click My Computer.
2. Right-click Local Disk C:.
3. Click Properties® Tools® Check Now.
4. Click Scan for and attempt recovery of bad sectors and click Start.
Windows Vista:
1. Click Start and click Computer.
2. Right-click Local Disk C:.
3. Click Properties® Tools® Check Now.
The User Account Control window may appear. If you are an administrator on the computer, click Continue;
otherwise, contact your administrator to continue the desired action.
4. Follow the instructions on the screen.

Error Messages

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions that
shipped with your computer. For additional safety best practices information, see the Regulatory
Compliance Homepage at www.dell.com/regulatory_compliance.
If the error message is not listed, see the documentation for the operating system or the program that was running when the
message appeared.
See Dell Diagnostics.
See Sound and Speaker
The optical drive must receive a steady stream of data during the writing process. If the stream is
Problems.
Search for the keyword standby in Windows Help and