Dell Vostro 220s Service Manual page 47

1 release latch
3 media card reader
6. Slide the device out through the front of the computer.
7. If you are installing a replacement device, skip to
If you are removing the device permanently and the drive bay is to remain empty, proceed to
8. Disconnect the USB interface cable from the system board (see
from the computer.
9. Install a 3.5-inch front-panel insert into the empty drive bay:
a. Holding the front-panel insert at an angle, insert one end into the drive bay opening.
b. Push the other end of the insert into the opening until it fits into place.
NOTE: To comply with FCC regulations, install the 3.5-inch front-panel insert whenever the device is permanently
removed from the computer.
2 optical drive bay
step 5 in Replacing or Adding a Media Card
System Board Components), and remove the cable
Reader.
step 8.