Removing An Optical Drive - Dell Vostro 220s Service Manual

NOTICE: The connectors are "keyed" for correct insertion; that is, a notch or a missing pin on one
connector fits with a tab or a filled-in hole on the other connector. Align the cable connectors correctly
before inserting them to avoid damage to the connectors.
11. Ensure that the other end of the USB interface cable is connected to a USB connector on the system board (see
System Board Components).
1 screws (2)
3 media card reader
12. Replace the bezel (see
13. Follow the procedure in
14. See the documentation that came with the drive for instructions on installing any software required for drive operation.
15. Enter the system setup program (see
Optical Drive
CAUTION: Before working inside your computer, read the safety information that shipped with your
computer. For additional safety best practices information, see the Regulatory Compliance Homepage at
www.dell.com/regulatory_compliance.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before
removing the cover.

Removing an Optical Drive

1. Follow the procedures in
2. Remove the computer cover (see
3. Remove the bezel (see
2 screw holes (2)
4 USB interface cable
Replacing the Bezel).
After Working on Your Computer.
System Setup Program
Before Working on Your
Removing the Computer
Replacing the Bezel).
for instructions) and update the drive settings.
Computer.
Cover).