Replacing The Processor Thermal-Cooling Assembly - Dell XPS M1530 Service Manual

1 fan cable connector
4. Disconnect the thermal fan cable connector from the system board.
NOTE: The fan is a part of the thermal-cooling assembly.
5. Tilt the thermal-cooling assembly slightly and lift it out of the computer.
Replacing the Processor Thermal-Cooling Assembly
CAUTION: Before working inside your computer, follow the safety instructions in the Product Information Guide.
NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your
computer's electronic components. You can do so by touching an unpainted metal surface.
NOTE: The original pad can be reused if the original processor and heat sink are reinstalled together. If either the processor or heat sink is replaced,
use the thermal pad provided in the kit to ensure that thermal conductivity is achieved.
NOTE: This procedure assumes that you have already removed the processor thermal-cooling assembly and are ready to replace it.
1. Peel the backing off the thermal cooling pad and adhere the pad to the portion of the thermal-cooling assembly that covers the processor.
2. Place the assembly on the system board.
3. Tighten the six captive screws and the M2.5 x 5-mm screw on the thermal- cooling assembly.
4. Replace the module cover.
Back to Contents Page
2 M2.5 x 5-mm screw