Download Print this page


Back to Contents Page
  Wireless Sniffer Board
Dell™ XPS™ M1530 Service Manual 
  Removing the Wireless Sniffer Board
  Replacing the Wireless Sniffer Board
Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
Handle components and cards by their edges, and avoid touching pins and contacts.
 Removing the Wireless Sniffer Board
1. Follow the instructions in
Before You
2. Remove any installed ExpressCards from the ExpressCard slot.
3. Remove the palm rest (see
4. Remove the ExpressCard reader (see
5. Disconnect the wireless sniffer board cable from the system board.
6. Remove the two M2 x 3-mm screws from each side of the sniffer board and remove it from the computer base.

1 wireless sniffer board

2 M2 x3-mm screw (2)
 Replacing the Wireless Sniffer Board
1. Replace the sniffer board.
2. Replace the two M2 x 3-mm screws on each side of the sniffer board.
3. Reconnect the wireless sniffer board cable to the system board.
4. Replace the ExpressCard reader (see
5. Replace the palm rest (see
6. Reinstall the ExpressCards in the ExpressCard slot, if any.
Removing the Palm
Removing the ExpressCard
3 wireless sniffer board cable connector
Replacing the ExpressCard
Replacing the Palm


   Also See for Dell XPS M1530

   Related Manuals for Dell XPS M1530

Comments to this Manuals

Symbols: 0
Latest comments: