Removing The Display Assembly - Dell XPS M1530 Service Manual

Back to Contents Page
Display Assembly
Dell™ XPS™ M1530 Service Manual
Removing the Display Assembly
Replacing the Display Assembly
Removing the Display Bezel
Replacing the Display Bezel
Removing the Display Panel
Replacing the Display Panel
Removing the Display Panel Cable
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as a connector on the back of the computer).
NOTICE: To help prevent damage to the system board, you must remove the battery from the battery bay before you begin working inside the
computer.
Removing the Display Assembly
1. Follow the instructions in Before You
2. Remove the Hinge Covers and the Center Control Cover (see
3. Turn the computer upside down and loosen the four captive screws along with the M2.5 x 5-mm screw. Remove the memory module cover.
1 M2.5 x 5-mm screw
3 captive screw (4)
4. Remove the Mini Card cables from the Mini Cards if applicable (see
5. Make note of the cable routing and carefully dislodge the Mini-Card antenna cables from their routing guides.
Begin.
Removing the Hinge Covers and Center Control
2 memory module cover
Wireless Mini Cards).
Cover).