Placing Originals On The Exposure Glass - Ricoh SP 311SFNw User Manual

Left
Bottom

Placing Originals on the Exposure Glass

This section describes the procedure for placing originals on the exposure glass and in the ADF.
• Do not place originals before any correction fluid and toner has completely dried. Doing so may
make marks on the exposure glass that will appear on copies.
• The original in the ADF takes precedence over the original on the exposure glass if you place
originals both in the ADF and on the exposure glass.
• Because colors made by marker or highlighter pen on originals are difficult to reproduce, they
might not appear on copies.
1. Lift the ADF.
Be careful not to hold the input tray when lifting the ADF, for the tray might be damaged.
2. Place the original face down on the exposure glass. The original should be aligned to the
rear left corner.
3. Lower the ADF.
Hold down the ADF with your hands when using thick, folded, or bound originals and the ADF
cannot be lowered completely.
Placing Originals in the Auto Document Feeder
By using the ADF, you can scan multiple pages at once.
In copier mode
3 mm
4 mm
CMF048
In scanner mode
0 mm
2 mm
Placing Originals
In fax mode
0 mm
0 mm
53