Table of Contents
Advertisement
O
PERATION
Basic Operation
The following example briefly describes how to use the Alpine Advanced Route Guidance
Navigation System.
1
The opening screen will appear once the
navigation system is turned on.
(If a CVA-1000/CVA-1005/IVA-C800 type
system control monitor is used, you may not
see this screen.)
2
A disclaimer screen appears. Please
read this important information. Press
the ENTER button on the remote control
if you accept this statement.
Once the ENTER button on the remote
control is pressed, the map screen will
appear on the display. The vehicle's
current location is indicated. If the
vehicle's current location is incorrect,
drive the car several miles in an area
with an open view to the sky. This will
correctly synchronize the navigation
system.
4
Press the MENU button on the remote
control. The main menu bar will appear
at the top of the screen. Tilt the joystick
to highlight the desired menu item then
press the ENTER button.
(In this example, "Dest" is selected.)
The Find Destination by menu
5
appears.
Tilt the joystick to select the desired
method, then press the ENTER button.
(This example shows when "Point of
Interest" is selected.)
ENTER
ENTER
Dest
ENTER
ENTER
Point of Interest
Continued next page
7
Advertisement
Table of Contents
