Page 1
NVE-M300P Version 2010/03/18 Software Update Guide...
Page 2
Introduction This Guidebook describes the procedure for updating the NVE-M300P software. Requirements High Speed Internet connection USB stick (minimum 64 MB) Prepare USB stick - Format USB stick Connect the USB stick to the PC. Right click on “Removable Disc”. The Drive name may vary on your PC and click “Format”.
Page 3
Prepare USB stick - Prepare update image Download the file “FU_NVE-M300P_xxxxxxxx.zip” to your PC. Extract the zip file onto the prepared USB stick. The USB stick must contain the following file and folders structure : Remove the USB stick by selecting “Safely Remove Hardware” on your PC.
Page 4
Update the NVE-M300P Install and switch-on the navigation system (Monitor with NVE-M300P). Connect the USB stick to the navigation system. Please use the USB cable delivered with the NVE-M300P. The system will reboot automatically after a few seconds. The update will start after the reboot.
Page 5
Initialisation of RUE-M300 Connect the USB IR Receiver RUE-M300 to the NVE-M300P via the USB cable delivered with NVE-M300P. Standard USB extension cables can be used if length is not sufficient. To activate RUE-M300, press any button at the remote controller except the TMC button.