Table of Contents
Advertisement
R
EFERENCE
In case of difficulty
If you encounter a problem, please review the items in the following checklist. This guide will help
you isolate the problem if the unit is at fault. Otherwise, make sure the rest of your system is
properly connected or consult your authorized Alpine dealer.
Symptom
Cause
The vehicle's
The vehicle's position changed
position is
after the ignition was switched
erroneous.
off.
• Movement on a ferry boat
• Rotation of a parking lot
turntable
• Movement by tow truck
The
Poor satellite reception
measurement
Not enough satellites to give
error is too
three dimensional positioning.
large.
Screen not
The navigation monitor is turned
displayed
off.
An error
The DVD-ROM is not inserted
message
properly.
regarding the
Disc dirty or damaged
DVD-ROM is
displayed
Inconsistent
The remote control batteries
operation/
are wearing out.
response of
remote control
No operation
Moisture condensation
Ambient temperature over
122°F (50°C)
Blown fuse
78
Solution
Drive the vehicle in an area of good GPS
reception to allow the unit to recalibrate
itself.
Move to a location where strong GPS
reception is possible.
Press the DISP ON/OFF button on the
remote control.
Set Power switch of monitor to Standby.
Eject the DVD-ROM and reinsert properly.
Clean or replace disc
Replace the remote control batteries.
Allow enough time for the condensation to
evaporate (about 1 hour).
Lower the temperature in the vehicle
below 122°F (50°C), by driving with the
windows open or air conditioner on.
Replace with a fuse of the prescribed
rating.
Advertisement
Table of Contents
