1 - 10 MC3000 Integrator Guide
Starting the Mobile Computer
When the mobile computer is powered on for the first time, it initializes. The
period of time, followed by the
Splash Screen
Figure 1-7
After the calibration procedure is performed the factory default settings launch the
specific shells may provide application specific windows instead of the
when a cold boot is performed.
If the mobile computer does not power on, see
Calibration Screen
Use the
Calibration
Remove the stylus from the stylus holder.
1.
Carefully press and briefly hold the tip of stylus on the center of the
2.
procedure as the target moves and stops at different locations on the screen. This enters the new calibration
settings.
Calibration Screen
Calibration Screen
Figure 1-8
Once all of the new calibration settings are input, the
3.
screen within 30 seconds to save the new calibration settings or allow the 30 second timer to expire and the
new calibration settings are not saved.
screen.
Calibration
OR
screen to align the touch screen:
Confirm Calibration
Resave Screen
Demo window
Resetting the Mobile Computer on page
Calibration
Confirm Calibration Resave
screen appears for a short
splash
. Application
Demo window
. These screens also appear
1-11.
screen target. Repeat the
screen appears. Tap the