Sliding The Server Out Of The Equipment Rack - Fujitsu SPARC ENTERPRISE M4000 Service Manual

5.1.1

Sliding the Server Out of the Equipment Rack

Caution – To prevent the equipment rack from tipping over, you must deploy the
antitilt feature, if applicable, before you slide the server out of the equipment rack.
Note – When drawing out the SPARC Enterprise M4000/M5000 Server to the front,
release the cable tie holding the PCI cables on the rear of the server.
Caution – Use proper ESD grounding techniques when handling components. See
"Safety Precautions" on page
1. Deploy the rack's antitilt features (if applicable).
Refer to the manual that shipped with the rack for details on antitilt features.
2. If shipping brackets are attached to the back of the server, loosen the four (4)
captive screws (
5-2 SPARC Enterprise M4000/M5000 Servers Service Manual • August 2009
1-1.
).
FIGURE 5-1