Accessing The 60-Mm Fan Module - Fujitsu SPARC ENTERPRISE M4000 Service Manual

10.1.1

Accessing the 60-mm Fan Module

1. From the XSCF Shell prompt, use the replacefru command to disable the
fan to be removed.
XSCF> replacefru
The replacefru command is menu-driven. replacefru will continue while the
fan is removed and then test the fan. Refer to
page 4-7
Caution – To prevent the equipment rack from tipping over, you must deploy the
antitilt feature, if applicable, before you slide the server out of the equipment rack.
Caution – When drawing out the SPARC Enterprise M4000/M5000 Server to the
front, release the cable tie holding the PCI cables on the rear of the server.
2. Deploy the rack's antitilt features (if applicable) and slide the server out of the
equipment rack.
See
Caution – Use proper ESD grounding techniques when handling components. See
"Safety Precautions" on page
10-4 SPARC Enterprise M4000/M5000 Servers Service Manual • August 2009
for more information.
"Sliding the Server Out of the Equipment Rack" on page
"Removing and Replacing a FRU" on
1-1.
5-2.