Fujitsu M4097D Operator's Manual page 3

Revisions, Disclaimers
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential instal-
lation. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
• Consult the dealer or an experienced radio/TV technician for help.
FCC warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the equip-
ment.
• The use of a non-shielded interface cable with the referenced device is
• The length of the power cord must be 3 meters (10 feet) or less.
E d t i o i n
0 1
0 2
0 3
S p
receiver is connected.
NOTICE
prohibited. The length of the parallel interface cable must be 3 meters (10 feet)
or less. The length of the serial interface cable must be 15 meters (50 feet) or less.
D a e t p u b s i l h e d
F e b u r r a , y 2 0 0 0
F e b u r r a , y 2 0 0 0
M a , y 2 0 0 0
e i c c i f t a o i n N . o C 1 5 0 E - 1
R e v s i e d c o n e t
F r i t s e d t i o i n
S e c o n d e d t i o i
T i h d r e d t i o i n
4 6 0 - 3 E N
n s t
n
i