Fujitsu M4097D Operator's Manual page 67

Reading Mode Setting When the Video Interface Option is Installed
This section describes the button specifications and setup details for each of the simplex (front-side),
duplex (front-side) and duplex (back-side) reading modes when the scanner has the video interface
option in the third party slot.
When the reading mode is set by the command from the host computer, the following button
operation is not required.
NOTICE
When the video interface option is installed in the scanner, the scanner automatically recognizes the
board and changes the display.
Whenever you press
1 Turn the power ON and verify that
"Scanner Ready" is displayed on the
LCD.
2 Press then the scanner displays
Screen M2.
3 Press then the scanner displays
Screen 1.
4 Select ADF or FB by pressing
then press
Screen 2.
5 Select "Simplex" or "Duplex" by pressing
or . Then press Enter. The scanner
displays Screen 3.
6-4
, the scanner returns to screen M1.
or
. The scanner displays
<Screen M1>
<Screen M2>
<Screen 1>
<Screen 2>