Fujitsu M4097D Operator's Manual page 77

2. Setting double feed detection (Paper Length)
1 Press or
scanner display Screen 42.
2 Press either the or
length is checked using the difference between two consecutive sheets of paper fed from the ADF.
Each time either of these switches is pressed,the location of the blinking moves. When the
switch is pressed, the blinking moves from (1) to (3). When the
moves in the opposite direction. However, if the setting by the host computer is valid, the location
of the blinking does not move when either switch is pressed.
(1) "No" is blinking:
(2) "Yes" and "1" are blinking:
(3) "Yes" and "2: Stop" are blinking: Paper length is checked. When the double feed error is
If you want to disable the double feed, select "No" then press
After pressing
3 Press either the or
double feed detection (paper length).
When the switch is pressed, the
blinking moves from (1) to (3). When the
switch is pressed, the blinking moves
in the opposite direction.
(1) The "10" is blinking: Threshold is 10mm
(2) The "15" is blinking: Threshold is 15mm
(3) The "20" is blinking: Threshold is 20mm
and let the
switch to set double feed detection according to paper length. The paper
Paper length is not checked.
Paper length is checked. However, a detected double feed
error is displayed on the screen only; processing is
continued.
detected, the scan processing is stopped. The error is then
reported to the host.
, the scanner displays the screen 42-1.
switch to set
<Screen 42>
switch is pressed, the blinking
. Press
<Screen 42-1>
to return.
7-5