Manual Feed Mode Setting
In this mode, the scanner waits for some predetermined time without issuing a "Paper Empty"
message after all documents are read. This predetermined time (time-out limit) is specified in the
Setup mode. Therefore you can set the next documents on the ADF chute without interrupting the
reading operation. The procedures for setting the manual feed mode are as follows:
1 Turn the power ON and verify that
"Scanner Ready" is displayed on the
LCD.
2 Press
then the scanner displays
Screen M2.
3 Press
then the scanner displays
Screen M3.
4 Press
then the scanner displays
Screen M4.
5 Select "Yes" by pressing
6 Press
to return to the "Scanner
Ready" screen. Note that "Manual Feed"
is shown on the LCD. This means that
the scanner is in Manual Feed mode.
<Screen M1>
<Screen M2>
<Screen M3>
<Screen M4>
. Then press
.
<Screen M1>
3-3