Fujitsu fi-5000N Operator's Manual page 75

5.6 Managing Scanner Information
■ [Device Set] Tab
You can display and configure the hardware settings and maintenance information of the scanner.
However, there may be items that cannot be displayed or configured (appears dimmed) depending
on the scanner.
The changed setting is reflected in the scanner after clicking the [OK] button.
This tab does not appear when the scanner is in use or not connected. If the tab does not appear,
exit the application that the scanner is using or check the connection, and then display the tab.
(To change the settings, the Administrator PIN is required.)
5
About Replacing Consumables
The approximate number of scanned pages since the last consumables replacement and the
remaining amount of imprinter ink are displayed in the red frame.
After replacing the consumables, you must click the corresponding [Clear] button to reset the
counter.
The consumables differ depending on the scanner. For further details refer to the Operator's Guide
supplied with the scanner.
61
fi-5000N Operator's Guide