Installing A 5.25-Inch Drive - HP ProDesk 600 Hardware Reference Manual
Hardware reference guide
Hide thumbs
Also See for ProDesk 600:
- Maintenance and service manual (245 pages) ,
- Quickspecs (58 pages) ,
- Illustrated parts & service map (4 pages)
Table of Contents
Advertisement
7.
Press down on the green drivelock mechanism (1) and slide the drive from the drive bay (2).
Installing a 5.25-inch drive
NOTE:
HP does not offer a 5.25-inch optical drive for this computer model. A 5.25-inch optical drive
can be purchased through a third-party vendor.
1.
Remove/disengage any security devices that prohibit opening the computer.
2.
Remove all removable media, such as compact discs or USB flash drives, from the computer.
3.
Turn off the computer properly through the operating system, then turn off any external devices.
4.
Disconnect the power cord from the power outlet and disconnect any external devices.
CAUTION:
as long as the system is plugged into an active AC outlet. You must disconnect the power cord
to avoid damage to the internal components of the computer.
5.
Remove the computer access panel.
6.
Remove the front bezel. If you are installing a drive in a bay covered by a bezel blank, remove
the bezel blank. See
ENWW
Regardless of the power-on state, voltage is always present on the system board
Removing bezel blanks on page 15
for more information.
Installing and removing drives
29
Hide quick links:
Advertisement
Table of Contents
