Installing A Slim Optical Drive - HP ProDesk 600 Hardware Reference Manual

Hardware reference guide
Hide thumbs Also See for ProDesk 600:
Table of Contents

Advertisement

7.
Push the green release lever on the right rear side of the drive toward the center of the drive (1),
then slide the drive forward and out of the bay (2).

Installing a slim optical drive

1.
Remove/disengage any security devices that prohibit opening the computer.
2.
Remove all removable media, such as compact discs or USB flash drives, from the computer.
3.
Turn off the computer properly through the operating system, then turn off any external devices.
4.
Disconnect the power cord from the power outlet and disconnect any external devices.
CAUTION:
as long as the system is plugged into an active AC outlet. You must disconnect the power cord
to avoid damage to the internal components of the computer.
5.
Remove the computer access panel.
6.
Remove the front bezel. If you are installing a drive in a bay covered by a bezel blank, remove
the bezel blank. See
7.
Before the new optical drive can be used, the release latch must be attached.
a.
Peel the backing off the adhesive on the release latch.
b.
Without allowing the release latch to touch the optical drive, carefully align the holes on the
release latch with the pins on the side of the optical drive. Make sure the release latch is
oriented properly.
c.
Insert the pin at the front of the optical drive into the hole at the end of the release latch,
and press firmly.
ENWW
Regardless of the power-on state, voltage is always present on the system board
Removing bezel blanks on page 15
for more information.
Installing and removing drives
37

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Prodesk 600 g1 sffProdesk 600 g1 towerProdesk 600 g1 small form factorE3s64utabaE1z76ut-aba

Table of Contents