Changing From Desktop To Tower Configuration - HP ProDesk 600 Hardware Reference Manual

Changing from desktop to tower configuration

The Small Form Factor computer can be used in a tower orientation with an optional tower stand that
can be purchased from HP.
1. Remove/disengage any security devices that prohibit opening the computer.
2. Remove all removable media, such as compact discs or USB flash drives, from the computer.
3. Turn off the computer properly through the operating system, then turn off any external devices.
4. Disconnect the power cord from the power outlet and disconnect any external devices.
CAUTION:
as long as the system is plugged into an active AC outlet. You must disconnect the power cord
to avoid damage to the internal components of the computer.
5. Orient the computer so that its right side is facing down and place the computer in the optional
stand.
NOTE:
optional tower stand.
6. Reconnect the power cord and any external devices, then turn on the computer.
NOTE:
remains clear and free of obstructions.
7. Lock any security devices that were disengaged when the access panel was removed.
ENWW
Regardless of the power-on state, voltage is always present on the system board
To stabilize the computer in a tower orientation, HP recommends the use of the
Ensure at least 10.2 centimeters (4 inches) of space on all sides of the computer
Changing from desktop to tower configuration 59